聯系我們
濟南富強門業有限公司
聯系人：林經理
電話：151 6888 2846
郵箱：527800164@qq.com
地址：濟南市歷下區化纖廠路8號3號樓101號
電動卷簾門下限位調節方法只需觸動微動開關
來源：http://www.wurkt.com 日期：2021-12-02 發布人：
注意觀察限位開關的動作變化和限位調整輪的運動變化。卷簾限位的控制，是通過轉動軸上兩個小輪的左右碰觸微動開關來實現的，左右移動兩個限位輪在運動的過程中，電動卷簾門下限位調節方法只需觸動微動開關即可實現。
Pay attention to observe the movement change of limit switch and the movement change of Limit Adjustment Wheel. The control of the roller shutter limit is realized by touching the micro-switch of the two small wheels on the rotating shaft. During the movement of the two limit wheels, the lower limit adjusting method of electric shutter door can be realized only by touching the micro-switch.
Pay attention to observe the movement change of limit switch and the movement change of Limit Adjustment Wheel. The control of the roller shutter limit is realized by touching the micro-switch of the two small wheels on the rotating shaft. During the movement of the two limit wheels, the lower limit adjusting method of electric shutter door can be realized only by touching the micro-switch.
卷簾下限調整方法：
Adjustment of the lower limit of the roller shutter:
Adjustment of the lower limit of the roller shutter:
先確定哪一種控制開關為下限位，一般濟南電動卷簾門升頂部，觀察哪一個微動開關處于“動作”狀態時，其為上限位開關，下限位開關。
First determine which kind of control switch for the lower limit, generally Jinan Electric Shutter door to the top, observe which micro-switch in the “Action”state, its for the upper limit switch, lower limit switch.
First determine which kind of control switch for the lower limit, generally Jinan Electric Shutter door to the top, observe which micro-switch in the “Action”state, its for the upper limit switch, lower limit switch.
尋找到更靠近該開關的調整輪是我們需要調整的。(輪距下限位開關越近，下限位開關動作越快，卷簾就越早停止下降，即卷簾下落的距離短；反之，卷簾下落的距離越長)
Find the adjusting wheel closest to the switch that we need to adjust. (the closer the wheel distance lower limit switch is, the faster the lower limit switch moves, the sooner the roller shutter stops falling, i. e. the shorter the falling distance of the roller shutter; conversely, the longer the falling distance of the roller shutter.)
Find the adjusting wheel closest to the switch that we need to adjust. (the closer the wheel distance lower limit switch is, the faster the lower limit switch moves, the sooner the roller shutter stops falling, i. e. the shorter the falling distance of the roller shutter; conversely, the longer the falling distance of the roller shutter.)
例如卷簾的下落距離太大，此時我們需要讓卷簾稍微提起一點停止，那么將此調節輪朝接近限位開關的方向移動即可，具體操作：
For example, the fall distance of the shutter is too large, at this time we need to let the shutter a little bit to stop, then the adjustment wheel near the limit of the direction of the switch can move, specific operation:
For example, the fall distance of the shutter is too large, at this time we need to let the shutter a little bit to stop, then the adjustment wheel near the limit of the direction of the switch can move, specific operation:
1、手動下卷簾停在適當的位置。
1. Manually lower the roller shutter and park it in place.
1. Manually lower the roller shutter and park it in place.
2、松開調整輪的固定螺釘，靠近限位開關方向移動，使限位開關“碰上”動作，擰緊調整輪螺釘即可。
2, loosen the adjusting wheel fixed screw, near the limit switch direction of movement, so that the limit switch “Touch”action, tighten the adjusting wheel screw can be.
2, loosen the adjusting wheel fixed screw, near the limit switch direction of movement, so that the limit switch “Touch”action, tighten the adjusting wheel screw can be.
提升卷簾，然后用手拉下，觀察卷簾位置是否合適。
Lift the shutter and pull it down by hand to see if it is in the right position.
Lift the shutter and pull it down by hand to see if it is in the right position.
濟南電動卷簾門的限位調整方法相同，需要注意的是上限調整不能過高，避免卷簾卷卷卷起，需謹慎操作！
Jinan Electric Shutter door limit adjustment method is the same, need to pay attention to the upper limit adjustment can not be too high, to avoid rolling up, NEED TO BE CAUTIOUS OPERATION!
Jinan Electric Shutter door limit adjustment method is the same, need to pay attention to the upper limit adjustment can not be too high, to avoid rolling up, NEED TO BE CAUTIOUS OPERATION!
開頭講到的原因，是因為卷簾程序設定為兩級降，需要按照控制面板的調試方法，調整為一步降。
At the beginning of the reason, because the shutter program is set to two-level down, in accordance with the control panel debugging method, adjust for a step down.
下一篇：銀行使用的濟南卷簾門根據轉動分為4種方式 上一篇：如何配置卷簾門遙控器學問大著呢
閱讀/ Recommended reading
- 工業卷簾門與普通卷簾門的差異化解析 2025-06-05
- 濟南卷簾門怎么辨別質量？ 2025-06-04
- 濟南廠房中自動卷簾門有什么優勢？ 2025-06-03
- 銀行級防護卷簾門：守護金融的“隱形衛士” 2025-05-26
- 濟南卷簾門廠家直銷藏著哪些「真香」優勢？3 大維度揭秘，看完秒懂！ 2025-05-22
- 濟南卷簾門性能如何：構建多維防護體系 2025-05-20
- 濟南卷簾門電機怎么選？ 2025-05-19
- 解析濟南卷簾門面對的一些問題及解決方法 2025-05-16
工業卷簾門的防盜性能怎么樣？
2025-06-06
工業卷簾門作為物流倉儲與生產車間的關鍵防護設施，其防盜性能直接關系到企業資產。現代工業卷簾門通過多維度技術升級，構建起物理防護與智能預警相結合的立體安防體系。 As a ...
